Transparent Hybrid Base, 8 ml
The base coat has a modernized composition and has successfully passed allergy tests. Therefore, using HEMA FREE Base ensures maximum comfort and safety for clients with all nail types, especially those with nail hypersensitivity. Thanks to its medium-viscosity consistency, the material spreads easily across the surface with minimal effort. The result is a super-durable, medium-hard coating. The HEMA FREE rubber base is a guarantee of safety for both the master and the client.
ADVANTAGES:
- modernized product composition;
- no HEMA monomer in the composition;
- tested on allergy sufferers;
- super adhesion;
- flexibility and moderate stiffness;
- hypoallergenic 12 Free formula;
- the exothermic reaction is less pronounced during polymerization;
- does not heat up to high temperatures on the nails, does not cause unpleasant sensations during polymerization;
- suitable for thin, damaged and sensitive nail plates;
- ideal consistency for leveling the nail plate;
- wide possibilities: strengthening, renovation, extending the free edge up to 2 mm in length;
- ultra-durable coating, no chipping or peeling up to 28 days.
THIN APPLICATION. APPLICATION METHOD:
- Prepare the nail plate with PNB buff, remove shine.
- Apply auxiliary fluids: Nail Dehydrator and Bond Control to the entire nail plate.
- Apply a very thin layer of HEMA FREE Base PNB, seal the free edge, dry for 60 seconds.
- Apply a thin, even layer. Cure in the lamp for 60 seconds.
- If necessary, remove tack with PNB Gel Cleanser.
- Create a coating/design, apply a PNB top coat.
LEVELLING TECHNIQUE. APPLICATION METHOD:
- Prepare the nail plate with PNB buff, remove the shine.
- Apply auxiliary fluids: Nail Dehydrator and Bond Control to the entire nail plate.
- Apply a very thin layer of HEMA FREE Base PNB, seal the free edge, dry for 60 seconds.
- Apply a second very thin layer of HEMA FREE Base PNB, apply a drop of base to the highest point of the nail and evenly extend it to the free edge.
- Polymerize in the lamp for at least 1.5 minutes.
- If necessary, remove the sticky layer with Gel Cleanser PNB.
- Apply a hybrid or decor varnish, apply a PNB top coat.
RECOMMENDATIONS:
- If there are no sensations, the coating thickness should not exceed 1 mm;
- When leveling the nail plate, the coating thickness should not exceed 1.5 mm for full polymerization of the product. It is recommended to work in a "conveyor" mode, polymerizing each nail for a few seconds, and finally letting it dry completely for 1-2 minutes, depending on the type of lamp and power;
- The exothermic reaction is more pronounced in summer at temperatures above 25 degrees. To avoid this, it is advisable to have an air conditioner in the workroom;
- You can also use the Low Heat Mode.
Comment